![]() Next, create a mount point and mount the newly created partition file system. Mounting New Ext4 Parition in File System We can label the partition using the e4label and e2label commands as follows. ![]() Writing superblocks and filesystem accounting information: done Next, you need to properly format the new partition with the ext4 file system type using the mkfs or mke4fs command as follows. Now exit the program using the quit command. Number Start End Size Type File system Flags To print the partition table on the device /dev/sdb or detailed information about the new partition, run the print command. ext4 creates a lot of overhead before any files are created and it requires space to store that data. If you see we start the space from 1 and ended at 14500 because we need to leave some space for the “pre-allocating” the overhead. Partition type? primary/extended? primary Set the start and end to establish the size of the partition. Now create a partition using the mkpart command, give it additional parameters like “primary” or “logical” depending on the partition type that you wish to create. Warning: The existing disk label on /dev/sdb will be destroyed and allĭata on this disk will be lost. Warning: Partition(s) on /dev/sdb are being used. Give the new disk a label using the mklabel command. Welcome to GNU Parted! Type 'help' to view a list of commands. Now we use parted command to start creating the partition on the selected storage device. Looking at the output in the above output, we have one hard disk added to the system and we will have partition disk /dev/sdb with the name SanDisk Cruzer Blade (scsi) and its file system is fat-32. Sector size (logical/physical): 512B/512B Number Start End Size File system Name Flagsġ 1049kB 538MB 537MB fat32 EFI System Partition boot, esp Sector size (logical/physical): 512B/4096 I am using my 16GB pen-drive and I will make it as a drive in my system. First list the partition by using fdisk -l or parted -l commands to identify the hard drive you want to partition.I assumed that you have added a new hard drive or pen drive to your Linux machine, in which you will create the new ext4 partition, and.For example, if you add a new disk drive to the system, you may want to partition the drive, and use the ext4 file system. It was designed as a progressive revision of the ext3 file system and overcomes a number of limitations in ext3.Īfter installation, it is sometimes necessary to create a new file system. The ext4 file system is a scalable extension of the ext3 file system. The ext4 or fourth extended filesystem is a widely-used journaling file system for Linux.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |